BoomsRigs and tackle makingTutorials

Making a spreader boom

While it’s possible to purchase spreader booms from retail outlets these tend to be either fixed width or made from fine wire. Where a substantial boom is required for hefty species such as cod, ling or conger the DIY route is the way to go. Norrie Southam explains how to go about producing this effective terminal tackle which fit neatly into your tackle box.

Tools Required

  • Round or half-round nosed pliers
  • Wire cutters
  • An electric drill
  • Drill bits (these should be of a size to allow two lengths of welding rod pass through but with a tight fit)
  • A base wire for forming bends and coils – this should be slightly larger than the welding rod diameter but again a snug fit – alternatively a cut down hook can be used for the purpose

Making a spreader boom pliers required Making a spreader boom jig required

Materials Required

  • 1.5mm stainless welding rods
  • Snap link swivels (these need to have a large enough body to allow for drilling)
  • Swivels
  • Shrink-tube or silicon tube (a heat source will be required to contract the shrink tube).

Making a spreader boom welding rods Making a spreader boom link swivels

Step 1– Drill the body of the swivel attached to the snap link – a vertical drill stand or pillar drill can make this easier and safer. As an alternative to the link swivels, a normal swivel can be used to which an oval split-ring can be attached.

Making a spreader boom link swivel

Step 2– Cut the welding rod to produce two equal lengths – approximately 40cm will give a finished boom of around 60cm when expanded.

Step 3– Form a coil at one end of the cut rod by winding it round the length of forming wire, squeezing the coils tightly together as you go. A five turn coil will suffice; then cut the spare end flush with the coil.

Making a spreader boom bending wires Making a spreader boom wire coil formed

Step 4– Bring the welding round so it lies parallel with forming rod and slide off the end. Repeat steps 2 to 4 for the second leg of the boom.

Making a spreader boom wire straightened Making a spreader boom coil formed

Step 5– Thread the two lengths of rod through the drill hole in the swivel and then through the open coil on the opposite ends.

Making a spreader boom swivel on wires at end

Step 6– Thread the shrink tube and swivel onto one end of the boom wire. Form a loop using the wire former and thread the swivel in this loop. Squeeze the short length against the boom wire and slip the shrink tube or silicon tube over the two lengths of wire and the swivel eye; ensuring that the second eye is free to rotate. Apply heat if using shrink tube. Repeat for the other leg of the boom.

 

Making a spreader boom forming eye Making a spreader boom eye formed Making a spreader boom swivel added Making a spreader boom shink tube

Your boom is now complete and can be stored in its collapsed state in the tackle box before extending it for use at sea.

Making a spreader boom completed

For a general spreader boom rig see here and a “ling” spoon rigged spreader is illustrated here.

Facebook Comments
general new and reports
Previous post

Humberside / Linconshire / Yorkshire - 13/03/10

Zziplex Islander boat rod decals
Next post

ZZIPLEX ISLANDER boat rod available only from UK HOOKS

Norrie Southam

Norrie Southam